HP Switch 2512 Manuel d'utilisateur télécharger pdf

Dynamic LACP Trunking

Dynamic LACP TrunkingDynamic LACP Trunking

Dynamic LACP Trunking

The example configurations below provide dynamic trunking between two HP Procurve Series 2500

Switches (Switch A and Switch B) using LACP (802.3ad) as the trunking protocol.

Another benefit, besides dynamic trunk formation, of an LACP trunk is port redundancy. If one of

the operational ports fails then one of the redundant "standby" ports becomes operational without

any user intervention.

To create a dynamic LACP trunk, configure ports at one end of the link to be LACP active - and

ensure that LACP is enabled at the other end.

Switch A is configured to provide six LACP active ports. Since the Series 2500 Switches support

one trunk group of up to four ports, the other two ports will be redundant "standby" ports.

Switch B is in its default configuration. As stated above for a dynamic LACP trunk, once one end of

the link is configured for LACP active, the only other requirement is that the port at the other end of

the link must have LACP enabled. Since the Series 2500 Switches have LACP enabled by default,

there is no need to modify Switch B from its default configuration.

This configuration example applies to the following products:

� J4812A HP Procurve Switch 2512

� J4813A HP Procurve Switch 2524

©Copyright Hewlett-Packard Company, 2000.

Page 1

1 2 3 4 5 6

Résumé du contenu

Page 1 - Dynamic LACP Trunking

Dynamic LACP TrunkingDynamic LACP TrunkingDynamic LACP TrunkingDynamic LACP Trunking The example configurations below provide dynamic trunking between

WARNING:WARNING:WARNING:NOTES:NOTES:NOTES:REQUIREMENTS/RESTRICTIONSREQUIREMENTS/RESTRICTIONSREQUIREMENTS/RESTRICTIONS:::WARNING: The example configura

Page 3

CONFIGURATION COMMANDS: (created on software version F.01.07)CONFIGURATION COMMANDS: (created on software version F.01.07)CONFIGURATION COMMANDS: (cre

Page 4

RESULTING CONFIGURATION:RESULTING CONFIGURATION:RESULTING CONFIGURATION:Switch B Switch B Switch B VERIFICATION COMMANDS:VERIFICATION COMMANDS:VERIFIC

Page 5

---- ------- ------- ------- ------- ----------- -------- ----HP ProCurve Switch 2524# sh lacp LACP PORT LACP TRUNK PORT LACP LACP NUMB ENABLED

Page 6

---- -------- ----HP ProCurve Switch 2524# sh log lacp Keys: W=Warning I=Information M=Major D=Debug Event Log listing: Events Since Boot I 01/01/9

Commentaires sur ces manuels

Pas de commentaire

HP Switch 2512 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Commutateurs de réseau HP Switch 2512. HP Switch 2512 User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau HP Switch 2512