HP 7000 dl Router Series Guide de l'utilisateur télécharger pdf (Page 392)

SROS Command Line Interface Reference Guide IKE Client Command Set

IKE CLIENT COMMAND SET

To activate the IKE Client , enter the crypto ike client command at the Global Configuration Mode

prompt. For example:

configure terminal

Router(config)#

crypto ike client configuration pool

Router(config-ike-client-pool)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on page 924

do on page 928

end on page 929

exit on page 930

ping <address> on page 931

show running-config on page 933

All other commands for this command set are described in this section in alphabetical order.

dns-server <address1> <address2> on page 393

ip-range <start ip> <end ip> on page 394

netbios-name-server <address1> <address2> on page 395

For VPN configuration example scripts, refer to the VPN Configuration Guide located on

the ProCurve SROS Documentation CD provided with your unit.

Pas de commentaire

HP 7000 dl Router Series Guide de l'utilisateur Page 392