HP tc2120 Server Guide d'installation télécharger pdf (Page 75)

7. Click Next

1.5 Network Configuration

NOTE: The installer should have detected all of your NICs at this point. If it does not, then you

may need to obtain a special NIC driver that may be installed after you have completed the

Red Hat Linux installation.

1. If you are using DHCP, then click next. Otherwise, select your first NIC and

click Edit.

2. If you chose DHCP, you can skip to step 7. Otherwise, deselect "Configure using

DHCP.”

3. Enter the IP address and netmask that corresponds to your network. Click OK.

4. Repeat steps 1 through 3 for each NIC.

5. Select "manually" for "Set the host name" and enter a host name for your

machine (e.g., HP-Netserver1).

6. Enter any required addresses for Gateway, Primary, Secondary, and Tertiary

DNS.

7. At the Firewall Configuration screen, choose the type of firewall configuration,

or "No Firewall" for none. If configuring a firewall, you may choose to "Use

default firewall rules,” or "Customize.” Click Next to continue.

NOTE: If you accidentally chose to install a firewall, and did not intend to, you can "rm

/etc/rc.d/rc[0-5].d/*iptables*" & "iptables -F" from the root prompt later to get rid of it.

1.6 More Installation Settings

1. On the "Additional Language Support" screen, select English (USA). Click

Next.

2. On the "Time Zone Selection" screen, select location. Click Next.

HP CONFIDENTIAL

Writer: Jimmy Chan File Name: 312977-006.doc

Codename: Condor II Part Number: 312977-006 Last Saved On: 9/10/03 10:05 AM

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 91 92

Pas de commentaire

HP tc2120 Server Guide d'installation Page 75