Hp Matrix Operating Environment Software Manuel d'utilisateur télécharger pdf (Page 107)

2. Go to the storage fabric and create the zone. In this example, a switch which exists in “san3”

above is connected. The zone should have the same name as the storage pool entry, as is

shown by the highlighted entry.

3. Go to the disk array management interface (in this case CommandView managing an EVA)

and create a host entry and present the LUN. In the first figure, the host entry that is created

on the EVA uses the same name as the storage pool entry. The host entry is assigned the

initiator WWN identified in the storage pool entry:

4. Create the vdisk on the EVA and present it to the host above:

Corrective procedures 107

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 127 128

Pas de commentaire

Hp Matrix Operating Environment Software Manuel d'utilisateur Page 107