HP z540 Guide de l'utilisateur télécharger pdf (Page 198)

188 Microsoft Windows XP Media Center Edition 2005 Reference Guide

Hardware and Operating System

Problem Possible solution

My remote control

does not work.

■ Make sure that the two AA alkaline batteries for the remote control are charged

and installed correctly.

■ Make sure the remote control sensor is plugged into a USB port on the

HP Digital Entertainment Center.

■ Make sure the front of the remote control sensor (IR Receiver) is not blocked.

■ Point the remote control within a 45-degree angle range and less than 26 feet

(8 meters) away from the remote sensor.

■ If a pressed key repeats itself or sticks, unplug the remote sensor from the USB

connector, wait 1 minute, and plug the remote sensor back in. Try altering the

lighting conditions in the room or moving the location of the remote sensor if this

continues.

■ Press the Enter button on the remote control after changing a channel.

■ Point the remote control toward the remote sensor, and press a button. A faint

red light should appear on the remote sensor. If the light appears, then the

problem is probably in the Media Center software. Close Media Center, restart

the HP Digital Entertainment Center, and then open Media Center again.

■ If the remote control works in Media Center but not when changing channels,

you may need to reconfigure the Media Center software settings for the cable

set-top box or satellite receiver.

Media Center is not

recognizing my

external device.

For Media Center to recognize your portable device such as a mass storage device,

USB drive, music storage device, or other, you must change the device settings. To

do this:

1 Connect your device.

2 Open Media Center by pressing the Media Center Start button on the

remote control.

3 Select More Programs, and then select Sync to Device.

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 215 216

Pas de commentaire

HP z540 Guide de l'utilisateur Page 198