HP F100 Manuel d'utilisateur télécharger pdf (Page 21)

Setting Up the HP ProLiant Cluster F100 21

Follow the installation instructions in the ProLiant server documentation to set up

the hardware. To install the HBAs and any NICs, follow the instructions in the

next section.

IMPORTANT: Refer to the MSCS support matrix for the supported

hardware, software, cluster-supported servers, and firmware version

levels the cluster requires. To obtain the matrix, access the High

Availability website (http://www.hp.com/servers/proliant/highavailability

click Cluster configuration support matrices in the Related

Information pane. Select the operating system, then the storage system

for your configuration to display the matrix.

Installing Host Bus Adapters

The HBAs that connect the two servers to the storage through Fabric switch or

Fibre Channel storage hub is installed in each server like any other PCI card.

Follow the installation instructions in the HBA documentation and the ProLiant

server documentation to install the HBAs in the servers.

Installing the Cluster Interconnect

There are a number of methods to physically set up an interconnect. Refer to the

cluster interconnect section for a description of the types of interconnect

strategies.

If you are using a dedicated interconnect, install an Ethernet interconnect adapter

card in each cluster node.

NOTE: HP recommends a dedicated NIC for the LAN and a dedicated

NIC for the interconnect of each cluster node.

For specific instructions on how to install an adapter card, refer to the

documentation for the interconnect card you are installing or the ProLiant server

you are using. The cabling of interconnects is outlined later in this chapter.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Pas de commentaire

HP F100 Manuel d'utilisateur Page 21