HP ProLiant DL370 G6 Spécifications rapides télécharger pdf (Page 18)

NOTE:

Memory configurations listed do not apply to "Factory Integrated Models".

HP ProLiant DL370 G6 Models

HP ProLiant ML370 G6 Models

DDR3 memory population guidelines

For detailed memory configuration rules and guidelines, please use the Online DDR3 Memory Configuration Tool:

www.hp.com/go/ddr3memory-configurator

Some DIMM installation guidelines are summarized below:

For servers with eighteen (18) memory slots:

There are three (3) channels per processor; six (6) channels per server

There are three (3) DIMM slots for each memory channel; eighteen (18) total slots

Memory channel 1 consists of the three (3) DIMMs that are closest to the processor

Memory channel 3 consists of the three (3) DIMMs that are furthest from the processor

DIMM slots that are white should be populated first

Do not mix Unbuffered memory (UDIMMs) with Registered memory (RDIMMs)

Do not install DIMMs if the corresponding processor is not installed

If only one processor is installed in a 2CPU system, only half of the DIMM slots are available

To maximize performance, balance the total memory capacity between all installed processors

It is not required, but it is recommended to load the channels similarly if possible

If any Quad rank DIMMs are installed, all channels are limited to only 2 DIMMs per channel.

You can only install two quad-rank DIMMs per channel

You can only install two UDIMMs per channel; if available, the third slot in the channel must remain empty

Populate DIMMs from heaviest load (quad-rank) to lightest load (single-rank) within a channel

Heaviest load (DIMM with most ranks) within a channel goes furthest from the chipset

For memory mirroring mode, channel 3 must be unpopulated. Channels 1 and 2 are populated identically

For lock-step mode, channel 3 must be unpopulated. DIMMs in channels 1 and 2 will be installed in pairs. The paired slots

will be 1,4; 2,5; 3;6 on a 3DPC system or 1,4; 2,5; on a 2DPC system

Low Voltage DIMMs can only be used with the Intel® Xeon® processors 5600 series

If mixing DIMM voltage is a requirement, please note that the DIMMs will run at 1.5V since all 1.35V are capable of

supporting 1.5V operations

DIMM slot/capacity/populated speed table

DIMM Type

Registered DIMMS

(RDIMMs)

Unbuffered with ECC DIMMs (UDIMMs)

DIMM Rank

Single Rank

(1R)

Dual Rank (2R)

Quad Rank (4R)

Single Rank

(1R)

Dual Rank (2R)

DIMM Capacity

2GB 4GB 8GB 8GB

16GB

4GB

16GB 32GB

1GB 2GB 4GB

DIMM Native Speed (MHz)

1333 1333 1333 1066 1333 1333 1066 1066 1066 1333 1333 1333

Voltage

LV/Std Std Std Std LV/Std LV/Std Std Std LV/Std Std Std Std

SLOTS THAT CAN BE POPULATED

18 slot servers

18 18 18 18 18 18 12 12 12 12 12 12

MAXIMUM CAPACITY (GB)

72 36 72 144 144 288 48 192 384 12 24 48

POPULATED DIMM SPEED (MHz)

1 DIMM Per Channel

1333 1333 1333 1066 1333 1333 1066 1066 1066 1333 1333 1333

2 DIMM Per Channel

1333

1066 1333

1066/

1033

800 800 800 1066 1066 1066

3 DIMM Per Channel

800 800 800 800 800 800

***

n/a n/a n/a n/a n/a n/a

* Supported with ROM update via ROM Based Setup Utility (RBSU)

**2DPC: LV runs at 1066, Std voltage runs at 1333

***3DPC: LV/Std voltage runs at 800

NOTES:

PC3-10600 DIMMs have a maximum speed of 1333MHz. PC3-8500 DIMMs have a maximum speed of 1066MHz

Mixing DIMM speeds is allowed, but the system processor speed rules always override the DIMM capabilities

If you do mix DIMM speeds, the memory bus will default to the minimum clock rate of all DIMMs in the system - even if the slower DIMM is on the other processor

If you install 1x 1066MHz DIMM in channel 1 and 1x 1333MHz DIMM in channel 2, the maximum speed will be 1066MHz

If you install 1x 1066MHz DIMM in channel 1 and 5x 1333MHz DIMMs with 1 DIMM Per Channel (DPC) in each of the other channels, the maximum speed will be 1066MHz

If you install 3DPC in one channel (if applicable) and 1DPC in all other channels, you run at 800MHz

Maximum memory speed will also depend on the processor

References to the above MHz speeds are for the various speeds of DDR3 DIMMs; 1333 refers to DDR3-1333, etc.

DIMM slot and configuration diagrams

Basic memory slot & population diagram

Population order; start with "A" first, "B" second, "C" third, etc.

18 DIMM SLOTS (9 per CPU node)

CPU1 CPU2

slot #

population order

slot #

population order

Chnl 1

Chnl 2

Chnl 3

Standard memory configuration (1 CPU model)

6GB, consisting of three (3) 2GB dual-rank PC3-10600 RDIMMs

CPU1 CPU2

slot #

population order

slot #

population order

Chnl 1

G; empty

Chnl 1

D; empty

A; 2GB DIMM

A; empty

Chnl 2

H; empty

Chnl 2

E; empty

B; 2GB DIMM

B; empty

Chnl 3

I; empty

Chnl 3

F; empty

C; 2GB DIMM

C; empty

Standard memory plus optional memory (1 CPU model)

54GB, consisting of three (3) 2GB RDIMMs plus six (6) 8GB RDIMMs

3x 2GB dual-rank PC3-10600 RDIMMs

6x 8GB dual-rank PC3-10600 or PC3-8500 RDIMMs

QuickSpecs

HP ProLiant DL370 Generation 6

Memory

DA - 13242 Worldwide QuickSpecs — Version 48 — 1/13/2012

Page 18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

QuickSpecs 1

Commentaires sur ces manuels

Pas de commentaire

HP ProLiant DL370 G6 Spécifications rapides Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour PC/postes de travail HP ProLiant DL370 G6