HP rp5000 Manuel d'utilisateur

1 Configuration Guide HP Point of Sale (POS) Accessories Document Version 1.00 May 2006

10 4.0 Windows Driver Installation Please install the Windows drivers for all of the accessories prior to install the OPOS drivers for the accessori

11 The following is the Device Manager window after the driver has been loaded:

12 4.3.0 Keyboard The HP POS keyboard uses native drivers for Windows XP Pro. Windows will load several drivers for the keyboard and touch pad. I

13 The following is the Device Manager window after all the drivers are loaded for the HP POS keyboard:

14 4.4.0 Scanner The HP POS scanner uses native drivers for Windows XP Pro. If during the driver installation Windows displays the new hardware wi

15 4.5.0 Magnetic Stripe Reader (MSR) The scanner is natively supported by Windows XP Pro as a Human Interface Device (HID). If during the driver i

16 4.6.0 If prompted for native driver location (New Hardware Wizard) The MSR / Scanner / POS keyboard use the native driver that comes with Windo

17 For the following screens accept the default option:

18 When finished, click “FINISH” to complete the installation of the native drivers.

19 5.0 OPOS Driver Installation On the HP rp5000 Windows XP Pro images the OPOS drivers for thermal printer / MSR have been installed in the image.

2 © Copyright 2006 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. Microsoft, MS-DO

20 6.0 Confirmation that Accessories are working outside of the Point of Sale Application If you have finished installing the drivers from the prev

21 The following is the main GUI of the A794_OPOS_SampleApp application when it is launched: After clicking “OPEN CASH DRAWER” the utility should

22 After clicking the “closing the cash drawer” button the utility will show the status of the cash drawer as “Cash Drawer is Closed or Not Connecte

23 The following is the main GUI of the HPSampleApp sample application when it is launched: When you select OPEN / ENABLE and the status should s

24 When you close the drawer the status changes to CLOSED: 6.2.0 Printer The following is an overview of the steps to test the printer followed

25 iv. Click on PrintBitmap button. The printer should have printed the selected bitmap. Barcode i. Select the bar code alignment (left / center

26 6.4.0 Scanner In order to test the scanner one can open an application like Microsoft Notepad and scan a barcode. You may use one of the barcod

27 7.0 Q & A Question: When I run the sample application I receive a message stating dependencies not correctly registered. How do I correct

3 Contents Introduction...

4 Introduction This document contains examples and information in regards to HP Point of Sale (POS) accessories. 1.0 List of Accessories 1.0.1 Har

5 2.0 Port Information 2.1.0 Ports The HP rp5000 uses a board in place of an expansion slot for 3 powered USB ports (two 12V USB ports & one 24V

6 3.0 Accessories Connection The USB accessories should be installed after the Windows XP Pro operating system has been unbundled. HP recommends

7 The following is the back of the printer with the cover closed: The following is the back of the printer with the cover open: Close-up of

8 Close-up of cash drawer connector on the back of the printer: 3.0.2 Printer The print will be installed in the 24V USB (powered) port. T

9 The 24V powered USB port is where the printer USB cable will plug into. This port is keyed differently than 12V powered USB connector: