HP EliteDisplay E230t 23-inch Touch Monitor Manuel d'utilisateur télécharger pdf (Page 18)

Removing the monitor stand

You can remove the display head from the stand to install the display head on a wall, a swing arm, or other

mounting xture.

CAUTION: Before beginning to disassemble the monitor, be sure that the monitor is turned o and all cables

are disconnected.

1. Disconnect and remove all cables from the monitor.

2. Lay the monitor face down on a at surface covered by a clean, dry cloth.

3. Push up on the latch near the bottom center of the monitor (1).

4. Swing the bottom of the stand up until the mounting plate clears the recess in the panel (2).

5. Slide the stand out of the recess (3).

Mounting the display head

The display head can be attached to a wall, swing arm, or other mounting xture.

NOTE: This apparatus is intended to be supported by a UL or CSA Listed wall-mount bracket.

If the monitor is TCO certied, the power cord plugged into the display head must be a shielded power cable.

The use of a shielded power cable meets the TCO Certied criteria for display products. For information on

TCO requirements, go to www.tcodevelopment.com.

CAUTION: This monitor supports the VESA industry standard 100 mm mounting holes. To attach a third-

party mounting solution to the display head, four 4 mm, 0.7 pitch, and 10 mm long screws are required.

Longer screws must not be used because they may damage the display head. It is important to verify that the

manufacturer’s mounting solution is compliant with the VESA standard and is rated to support the weight of

the display head. For best performance, it is important to use the power and video cables provided with the

monitor.

1. Remove the display head from the stand. Removing the monitor stand on page 12.

12 Chapter 1 Getting Started

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 37 38

Pas de commentaire

HP EliteDisplay E230t 23-inch Touch Monitor Manuel d'utilisateur Page 18