HP L919g Manuel d'utilisateur télécharger pdf (Page 21)

Setting Up the Monitor

Mounting the Monitor

The monitor panel can be mounted on a wall, a swing arm, or

other mounting fixture.

1. If the stand base is attached, follow the procedure in

“Removing the Stand Base” at the beginning of this chapter.

CAUTION: Before beginning to disassemble the monitor, be sure

the monitor is turned off and the power and signal cables are both

disconnected. If your monitor has a connected audio cable,

disconnect it.

After the base is removed from the monitor, four threaded

mounting holes are exposed on the monitor back panel to be used

for mounting purposes. These mounting holes are spaced 100mm

apart and are compliant with the Video Electronics Standards

Association (VESA) standard for mounting flat panel displays.

CAUTION: This monitor supports the VESA industry standard

100mm mounting holes. To attach a third party mounting solution to

the monitor, four 4mm, 0.7 pitch, and 10mm long screws are

required (not provided with the monitor). Longer screws should not be

used because they may damage the monitor. It is important to verify

that the manufacturer’s mounting solution is compliant with the VESA

standard and is rated to support the weight of the monitor display

panel. For best performance, it is important to use the power and

video cable provided with the monitor.

User Guide 3–9

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Pas de commentaire

HP L919g Manuel d'utilisateur Page 21