HP W22 Manuel d'utilisateur télécharger pdf (Page 22)

Power Cord Set Requirements

The monitor power supply is provided with automatic line switching (ALS). This feature allows the monitor to

operate on input voltages in the range of 100–240V∿, 50/60 Hz, 1.5A.

The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the

country/region where the equipment was purchased.

If you need to obtain a power cord for a different country/region, you should purchase a power cord that is

approved for use in that country/region.

The power cord must be rated for the product and for the voltage and current marked on the product’s electrical

ratings label. The voltage and current rating of the cord should be greater than the voltage and current rating

marked on the product. In addition, the cross-sectional area of the wire must be a minimum of 0.75 mm² or

18AWG, and the length of the cord must be between 4.94 ft (1.5 m) and 12 ft (3.6 m). If you have questions

about the type of power cord to use, contact your HP-authorized service provider.

A power cord should be routed so that it is not likely to be walked on or pinched by items placed upon it or

against it. Particular attention should be paid to the plug, electrical outlet, and the point where the cord exits from

the product.

Pin Assignments

Pin Number 15-Pin Side of

the Signal Cable

1 Video-Red

2 Video-Green

3 Video-Blue

4 Ground

5 Detect Cable

6 GND-R

7 GND-G

8 GND-B

9 +5V

10 Ground

11 Ground

12 DDC-Serial data

13 H-sync

14 V-sync

15 DDC-Serial clock

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Pas de commentaire

HP W22 Manuel d'utilisateur Page 22