HP Projector TC33096003 Manuel d'utilisateur télécharger pdf (Page 14)

Master on primary IDE

append="hda=ide-scsi"

Slave on primar y IDE

append="hdb=ide-scsi"

Master on secondary IDE

append="hdc=ide-scsi"

Slave on secondary IDE

append="hdd=ide-scsi"

2. Update your system conﬁguration, using the following command:

lilo

3. Save the ﬁle and reboot your system.

4. Verify that the change has been implem ented, using the following comma nd:

cat /proc/cmdline

5. If hda=ide-scsi (or s imilar) does not appear, you did not update the conﬁguration ﬁle correctly.

Start over with Step 1 above.

6. Verify that your system detects the tape device, using the following command:

cat /proc/scsi/scsi

To update the conﬁguration ﬁle and verify the conﬁguration (GRUB)

1. Locate the grub.conf ﬁle. This ﬁle may also be called menu.lst. Possible locations include

/boot/grub and /etc.

2. Add the appropriate text from the following to the end of each kernel image line in the grub.conf

ﬁle:

Master on primary IDE

hda=ide-scsi

Slave on primar y IDE

hdb=ide-scsi

Master on secondary IDE

hdc=ide-scsi

Slave on secondary IDE

hdd=ide-scsi

Each kernel image line will read similar to the following:

kernel /vmlinuz-2.2.6-2 ro root=/dev/hda3 hda=ide-scsi

3. Save the ﬁle and reboot your system.

4. Verify that the change has been implem ented, using the following comma nd:

Installation Notes

1 2 ... 9 10 11 12 13 14 15 16 17

Pas de commentaire

HP Projector TC33096003 Manuel d'utilisateur Page 14