HP RP7 Retail System Model 7100 Manuel d'utilisateur télécharger pdf (Page 20)

Connecting the base station

You can connect the base station to a terminal, PC, or other host device. Turn o power to the host before

connecting and consult the manual for that equipment (if necessary) before proceeding. Connect the interface

cable before applying power to the base station.

NOTE: The scanner can also be powered by the terminal. When powered by the terminal, the battery

charger is automatically set to slow charge.

Base station connection: Fully insert the Interface (I/F) cable (1) connector into the port on the underside of

the base station (2).

Host connection: Connect the Interface (I/F) cable (1) to a USB port on the host.

NOTE: The scanner can be set up to require a PIN code when connecting to the host. If you are adding new

equipment to a system that uses a custom security PIN, see the HP Wireless Barcode Scanner Programming

Reference Guide (PRG) for information before proceeding.

Disconnecting the cable: To detach the cable, insert a paper clip or similar object into the hole on the base

(1).

14 Chapter 4 Setting up and using the scanner

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

Pas de commentaire

HP RP7 Retail System Model 7100 Manuel d'utilisateur Page 20