HP Compaq Microtower Business PC dx2300 Guide de l'utilisateur télécharger pdf (Page 11)

Removing a 5.25" Drive Bezel Blank

If the computer was not shipped with a drive in the 5.25" option bay, the bay will be covered by a bezel

blank. If you add a drive to the option bay, you must first remove the bezel blank.

1. Turn off the computer properly through the operating system, then turn off any external devices.

2. Disconnect the power cord from the power outlet and the computer, and disconnect any external

devices.

3. Remove the access panel and front bezel. Refer to

Removing the Computer Access Panel and

Front Bezel on page 3.

4. While facing the inside of the front bezel, press the two retaining tabs on the right towards the outer

edge of the bezel (1) and pull the bezel blank inwards to remove it (2).

Figure 2-3 Removing a 5.25" Bezel Blank

NOTE: To install a 5.25" bezel blank, slide the left side of the blank into the two retainer slots

on the left side of the front bezel then snap the right side of the blank into place.

ENWW Removing a 5.25" Drive Bezel Blank 5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Pas de commentaire

HP Compaq Microtower Business PC dx2300 Guide de l'utilisateur Page 11