Hp Integrity NonStop H-Series Manuel d'utilisateur télécharger pdf (Page 12)

Installing and Configuring the Tape Drive for the

NonStop S-Series Server

5243-2SE Tape Drive Installation and User’s Guide—542757-003

2-2

Installation

3. Complete these steps first for the drive on the left side of the unit and then for the

tape drive on the right:

a. Connect one end of the SCSI cable to the corresponding SCSI port at the rear

of the tape drive. For the location, see Figure 2-2 and Figure 2-3.

b. Hand tighten the screws to secure the cable to the unit.

c. Connect the opposite end of the SCSI cable to the NonStop S-series server.

The tape drive can connect to the ServerNet/DA, IOMF2 CRU, or PMF

CRU

on the NonStop S-series server.

You can use any of the SCSI cables listed in Table 2-1.

Note. The tape drive’s SCSI IDs come preconfigured to SCSI ID 5. If you need to change

the SCSI IDs, use a screwdriver. Do not use a lead pencil.

Figure 2-2. Rear View of Tape Drive

Table 2-1. SCSI Cables

Model Number Description

519-003W 3 meter copper SCSI cable

519-015W 15 meter copper SCSI cable

519-020W 20 meter copper SCSI cable

519-023W 23 meter copper SCSI cable

SCSI ID SCSI Ports Fan Power Connectors Fan SCSI Port SCSI ID

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Pas de commentaire

Hp Integrity NonStop H-Series Manuel d'utilisateur Page 12