Hp Netserver E Server series Manuel d'utilisateur télécharger pdf (Page 43)

Chapter 5 Error Message Reference

Code Description Recommended Action

6. Be sure the processor board (if any) is seated.

7. Make sure the CPU chip is seated. (Take ESD precautions.)

8. Make sure the memory elements (DIMMs) are properly seated.

9. Check system fans. If overheating occurs, chip may shut down.

10. If the system ran with temperature high, let it cool for 30 minutes, then

restart.

11. If system repeatedly shows this error, replace the element with the CMOS.

00A4h NVRam base

address is invalid.

1. Run the BIOS Setup program and reconfigure all settings.

2. If necessary, update the BIOS.

3. Clear the CMOS and rerun configuration. See directions on the technical

reference label or card.

4. Make sure the system board is seated.

5. Check the seating of the voltage regulator module (VRM) if present.

6. Be sure the processor board (if any) is seated.

7. Make sure the CPU chip is seated. (Take ESD precautions.)

8. Make sure the memory elements (DIMMs) are properly seated.

9. Check system fans. If overheating occurs, chip may shut down.

10. If the system ran with temperature high, let it cool for 30 minutes, then

restart.

11. If system repeatedly shows this error, replace the element with the CMOS.

00A5h PnP function 42

failed.

1. Run the BIOS Setup program and reconfigure all settings.

2. If necessary, update the BIOS.

3. Clear the CMOS and rerun configuration. See directions on the technical

reference label or card.

4. Make sure the system board is seated.

5. Check the seating of the voltage regulator module (VRM) if present.

6. Be sure the processor board (if any) is seated.

7. Make sure the CPU chip is seated. (Take ESD precautions.)

8. Make sure the memory elements (DIMMs) are properly seated.

9. Check system fans. If overheating occurs, chip may shut down.

10. If the system ran with temperature high, let it cool for 30 minutes, then

restart.

11. If system repeatedly shows this error, replace the element with the CMOS.

00A6h PnP function 43

failed.

1. Run the BIOS Setup program and reconfigure all settings.

2. If necessary, update the BIOS.

3. Clear the CMOS and rerun configuration. See directions on the technical

reference label or card.

4. Make sure the system board is seated.

5. Check the seating of the voltage regulator module (VRM) if present.

6. Be sure the processor board (if any) is seated.

7. Make sure the CPU chip is seated. (Take ESD precautions.)

8. Make sure the memory elements (DIMMs) are properly seated.

9. Check system fans. If overheating occurs, chip may shut down.

10. If the system ran with temperature high, let it cool for 30 minutes, then

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 84 85

Commentaires sur ces manuels

Pas de commentaire

Hp Netserver E Server series Manuel d'utilisateur Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel informatique Hp Netserver E Server series