Hp ProLiant DL380 Server Manuel d'utilisateur télécharger pdf (Page 23)

Operations 23

To remove the component:

1. Power down the server if performing a non-hot-plug installation or maintenance procedure ("Power

down the server" on page 21).

2. Extend the server from the rack (on page 21).

3. Use the T-15 Torx screwdriver attached to the rear of the server to loosen the security screw on the hood

latch.

4. Lift up on the hood latch handle, and then remove the access panel.

Install the access panel

1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past the

rear of the server approximately 1.25 cm (0.5 in).

2. Push down on the hood latch. The access panel slides to a closed position.

3. Use the T-15 Torx screwdriver attached to the rear of the server to tighten the security screw on the hood

latch.

Access the product rear panel

Opening the cable management arm

To access the server rear panel:

1. Release the cable management arm.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 127 128

Pas de commentaire

Hp ProLiant DL380 Server Manuel d'utilisateur Page 23