Hp ProLiant XL220a Gen8 v2-Server Manuel d'utilisateur télécharger pdf (Page 14)

Operations 14

Remove the processor air baffle

1. Power down the server (on page 12).

2. Disconnect all peripheral cables from the server.

3. Remove the server (on page 13).

4. Remove the processor air baffle.

Remove the PCI riser board assembly

1. Power down the server (on page 12).

2. Disconnect all peripheral cables from the server.

3. Remove the server (on page 13).

4. Place the server on a flat, level work surface.

5. Disconnect all cables connected to existing expansion boards.

IMPORTANT: Both T-10 and T-15 screws are required for this procedure. When replacing the

component, be sure to install the screws in the proper location. Failure to do so will cause the

server to not install properly into the chassis.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 73 74

Pas de commentaire

Hp ProLiant XL220a Gen8 v2-Server Manuel d'utilisateur Page 14