Hp S7300CL Manuel d'utilisateur télécharger pdf (Page 14)

10 Upgrading and Servicing Guide

• If you have an 8000 series, continue to step 2.

• If you have an S0000 series, skip to step 3.

2 For the 8000 series, secure the expansion card to

the chassis with the slot cover screw.

3 For both the S0000 and 8000 series, if you have

replaced an expansion card, store the old card in

the anti-static packaging that contained your new

card.

• If you have an S0000 series, continue to step 4.

• If you have an 8000 series, skip to step 5.

4 For the S0000 series, replace the expansion cover

bracket (1) and screw (2).

replacing the expansion bracket cover on the

S0000 series

5 For both the S0000 and 8000 series, complete the

procedure described in “reassembling the pc” on

page 10.

reassembling the pc

1 Replace the front bezel by following the method

appropriate for your PC model.

• To replace the front bezel on the S0000 series,

position the chassis in the upright position. At an

angle, align the top of the front bezel with the

top slots of the chassis (1) so that the front bezel

hooks onto the chassis, and then press the

bottom end of the bezel to the chassis until it

snaps into place (2).

replacing the front bezel on the S0000 series

• To replace the front bezel on the 8000 series,

lay the chassis on the side with the open side up.

Place the front bezel in the correct position.

Ensure the slots (2) are aligned correctly, and

rotate the bezel toward the chassis (1) until it

snaps into place.

replacing the front bezel on the 8000 series

2 For either the S0000 or 8000 series, place the side

access panel in the proper position on the chassis

and slide it into place (1). Ensure that the hole for

the thumbscrew(s) align with the hole in the chassis

(2), and replace the thumbscrew(s).

1 2 ... 9 10 11 12 13 14 15 16

Pas de commentaire

Hp S7300CL Manuel d'utilisateur Page 14