Hp TC4100 Manuel d'utilisateur télécharger pdf (Page 28)

Chapter 3 Installing and Configuring

5. To remove the bezel, first remove the left cover by pulling the plastic latch out. Then press down the two

self-locking tabs to release the bezel. The right tabs slide out without removing the right cover. See

Figure 3-3.

Figure 3-3. Removing the HP Server tc4100 Bezel

6. If necessary, remove the right side cover by lifting the plastic latch.

The right cover only provides access to the Power Distribution Board and Floppy Disk Drive.

7. Pull the cover forward and then slightly sideways to disengage it.

8. Move it to the right and away from the chassis.

CAUTION To prevent damage to the covers, support the cover as you remove it from the HP Server

tc4100. The Server’s covers can be easily damaged.

Note:

Remove left cover and press

in on two self-locking tabs to releas

the bezel. Right tabs will slide out

without removing the right cover.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 129 130

Pas de commentaire

Hp TC4100 Manuel d'utilisateur Page 28