Hp COMPAQ DX2718 MT Manuel d'utilisateur Page 53

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 107
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 52
Service Reference Guide 483941-001 6–17
Removal and Replacement Procedures— Microtower (MT)/Small Form Factor (SFF) Chassis
6.8 Drives
The computer supports up to four drives that may be installed in various configurations.
This Section describes the procedure for replacing or upgrading the storage drives. A Torx T-15
screwdriver is needed to remove and install the guide screws on a drive.
Ä
CAUTION: Make sure personal files on the hard drive are backed up to an external storage device
before removing the hard drive. Failure to do so will result in data loss. After replacing the primary hard
drive, you will need to run the Restore Plus! CD to load the Compaq factory-installed files.
6.8.1 Locating Drive Positions
Drive Positions
*
*
* These apply for selected models and countries only.
Vue de la page 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 106 107

Commentaires sur ces manuels

Pas de commentaire