Hp Compaq t5510 Thin Client Manuel d'utilisateur télécharger pdf (Page 97)

5-41

Setup Menus

Selecting End on Non-Hex enables you to specify the number of characters that make

up the end sequence in the End Length box. The bypass will then terminate as soon as

a non-hexadecimal character is received (any character except in the range 0 through 9

and A through F) followed by the end sequence.

Characters can be entered in several ways. For example, to specify the ASCII escape

character, you can enter either _027, \u001B, \e, \033, or even ^[.

Font

This enables you to specify the font to be used for displaying characters. The available

settings depend on the fonts installed.

SBCS, APL2 & DBCS

The Single Byte Character Set, APL2 and Double Byte Character Set options enable

you to change the settings used by default for the chosen language. These should only

be changed by the System Administrator. If they have been changed and you wish to

restore the default settings in this dialog box, click the Default button. The following

table shows the default settings. A list of IBM EBCDIC codepages supplied can be

found at the end of the Character Sets appendix.

Note: Double byte character sets may not be supported by this

version of the emulator.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 337 338

Pas de commentaire

Hp Compaq t5510 Thin Client Manuel d'utilisateur Page 97