Hp LC 2000 Manuel d'utilisateur télécharger pdf (Page 98)

Chapter 8 Rack-Mounting the HP NetServer

Figure 8-9. Removing the Mounting Handles

10. Insert the flathead screws into the slides’ holes at the rear and the panheads

screws in the other four places to secure the chassis to the slides.

11. Use a T-15 Torx driver to remove the screws holding the handles to the

NetServer. See Figure 8-9.

12. Take the handles off the NetServer and store the handles and screws in a

convenient place. See Figure 8-9.

The handles can be re-attached whenever you remove the NetServer from

the rack. If moving the NetServer elsewhere, always package it with the

handles attached.

13. Press in the release latches on each slide, and push the NetServer all the

way into the rack. See Figure 8-10.

The blue Slide Release buttons in the Bezel moldings on each side of

chassis’ front edge must click into the latches in the column adapters on the

two front rack columns.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 193 194

Pas de commentaire

Hp LC 2000 Manuel d'utilisateur Page 98