HP Imaging and Printing Security Center Manuel d'installation télécharger pdf (Page 19)

system, and then complete a full installation of the HP Imaging and Printing Security Center. The

following figure shows the installation.

Figure 2-3 User interface and service on computer A — Database on computer B

Use the following steps to install the HP Imaging and Printing Security Center:

1. Log on to the computer where the HP Imaging and Printing Security Center database will run

(computer B in the figure).

2. Install and configure the Microsoft SQL Server on this computer, if required. (See the Microsoft

SQL Server installation and configuration documentation for instructions.)

NOTE: By default Microsoft SQL Server Express does not allow remote connections. If

Microsoft SQL Server Express is used in this configuration, use the instructions at the Microsoft

Web site (

http://support_microsoft.com/kb/914277) to allow remote connections.

3. Copy the HP Imaging and Printing Security Center installation program (HPIPSC_Setup.exe) to

this computer.

4. Double-click the installation program HPIPSC_Setup.exe and then click Next at the welcome

prompt.

5. Review and click the I accept the terms of the license agreement button to accept the license

agreement and then click Next.

ENWW Install the HP Imaging and Printing Security Center system 13

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Pas de commentaire

HP Imaging and Printing Security Center Manuel d'installation Page 19