HP NetServer NetRAID-4M Manuel d'utilisateur télécharger pdf (Page 10)

HP NetRAID-4M Cluster Services Installation Guide Hardware, Drivers and Utilities

2.2 Install the NetRAID-4M and Heartbeat NIC

1. Power off both Server A and Server B.

2. Disconnect all cables from the back of Server A.

3. If working on a racked server, extend the rack enclosure foot.

4. Extend Server A and open the cover to gain access to the PCI slots.

5. Insert an HP D5013B NIC into any 32-bit slot available in the server:

6. Verify that the HP NetRAID-4M termination jumpers are installed as shown in the

following graphic.

7. Verify the Battery Enable Jumper is properly installed on both pins as shown below.

NOTE Note: The card ships from HP with this jumper installed on only one of the two

pins.

8. Insert the HP NetRAID-4M into any 64-bit PCI slot available in the server.

9. Close Server A and if working on a racked server, slide the server back into the rack

enclosure.

10. Reconnect the video, keyboard, mouse, power, and network cables.

Jumpers

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Pas de commentaire

HP NetServer NetRAID-4M Manuel d'utilisateur Page 10