HP Tool Storage 354903-001 Manuel d'utilisateur télécharger pdf (Page 17)

Removal and Replacement Procedures 17

− The blower begins operating immediately.

− The power supply/blower assembly LED is green.

Hot-Plug Power Supply

Observe the following conditions for AC power supplies:

CAUTION: Removing a power supply significantly changes

the airflow within the chassis. The storage system will shut down to

prevent overheating unless the power supply is replaced within

5 minutes.

CAUTION: Handle the blower carefully to avoid damaging the

housing:

• Do not press on the center section of the blower because this action

can damage the blades. Press only on the outer edge of the blower.

• Do not rest the power supply on the blower because the weight of

the power supply can damage the blower housing.

To remove the component:

1. Disconnect the power cord from the power supply.

2. Remove the blower ("Blower" on page 16

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 51 52

Pas de commentaire

HP Tool Storage 354903-001 Manuel d'utilisateur Page 17