HP D2D2502i Guide de l'utilisateur télécharger pdf (Page 121)

system set description

Description of Command Function

Defines the string used to label and identify the StoreOnce appliance. This label is part of the

replication process when the source or target appliance needs to be identified.

Command Syntax

system set description <appliance-name>

Command Authority

Administrator

Command Object Requirements

Not applicable – no objects exist within this command.

Command Parameter Requirements

appliance-name – a character string must appear after config set description in the

command entry. This string may contain the upper case letters, lower case letters, numbers, the

dash “-“ and the underscore “_”. The string must be a maximum of 32 characters.

Requirements for Command Execution

The command entry must conform to the command syntax.

Successful Command Output

Upon successful completion of the command, the following is displayed:

The StoreOnce appliance description is APPLIANCE-NAME, where APPLIANCE-NAME

is the string labeling the StoreOnce appliance.

Command Operation during Abnormal Conditions

If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

Example

# system set description Primary-D2D

The D2D appliance description is Primary-D2D

system set description 121

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 177 178

Pas de commentaire

HP D2D2502i Guide de l'utilisateur Page 121