HP Modular Cooling System Manuel d'installation Page 1

HP Modular Cooling System G2 Installation Overview

Legal notices © Copyright 2007 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The

Optimum environment and site preparation CAUTION: Contaminated water might cause decreased cooling capacity or disruption in service. The water

CAUTION: Contaminated water might cause decreased cooling capacity or disruption in service. The water flowing into the MCS unit must meet the guide

11. Cap the unused side of each T-fitting on the MCS unit using the cap wrench. 12. Route the two drain hoses to the drain collection system catch

17. If you are using a secondary power cord, plug it into the power connector on the right. 18. Guide the other ends of the power cords through the

b. In the password field, enter the password. The default password is Admin. The Main Menu screen appears. 7. Enter the product ID and serial numbe

b. Enter 4 Activate Actual Values. c. To reboot, enter y at the prompt. You must reboot to activate the IP settings, product ID, and serial number v

20. (Optional, but recommended) To set up your SNMP managers, click Setup>Management>SNMP Managers. 21. Click Save Settings. For more informa

9. (Optional) Enter an SSL key. 10. Click Save Settings. 11. To set up your trap receivers, click Setup>Management>Trap Receivers. 12. Cli