Hp AMD Geode ECM-5510 Manuel d'utilisateur télécharger pdf (Page 23)

User’s Manual

ECM-5510 User’s Manual

2.2 Installation Procedure

This chapter explains you the instructions of how to setup your system.

1. Turn off the power supply.

2. Insert the DIMM module (be careful with the orientation).

3. Insert all external cables for hard disk, floppy, keyboard, mouse, USB etc. except for flat

panel. A CRT monitor must be connected in order to change CMOS settings to support

flat panel.

4. Connect power supply to the board via the ATXPWR.

5. Turn on the power.

6. Enter the BIOS setup by pressing the delete key during boot up. Use the “LOAD BIOS

DEFAULTS” feature. The Integrated Peripheral Setup and the Standard CMOS Setup

Window must be entered and configured correctly to match the particular system

configuration.

7. If TFT panel display is to be utilized, make sure the panel voltage is correctly set before

connecting the display cable and turning on the power.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 110 111

Pas de commentaire

Hp AMD Geode ECM-5510 Manuel d'utilisateur Page 23