Hp LTO 4 SAS Manuel d'utilisateur télécharger pdf (Page 14)

HP (HP-UX) servers and workstations12

The lunpath hardware path for the above tape drive is

“0/4/1/0.0x50060b0000b7f3c8.0x0”.

• The FC bus ID is “0/4/1/0” (including all the numbers separated by “/”).

From the remaining “0x50060b0000b7f3c8.0x0” portion:

• Tape drive WWN (hexadecimal) = 0x50060b0000b7f3c8

• Tape drive SCSI LUN = 0x0 (hexadecimal SCSI-3 64-bit LUN identifier)

Adding stape and schgr (autoloader driver) to the kernel

For HP-UX 11i v1, 11i v2

If your tape drive or autoloader does not appear in ioscan listing or is listed with H/W Type

“UNKNOWN” you may need to install the appropriate drivers.

Use the ‘sam’ utility. Sam runs as a mouse driven GUI (Figure 1) on a system with full graphics

capability, or as a console text-based interface (Figure 2). If you use the text-based interface, use the

Tab and arrow keys to navigate, and the Return key to select.

Figure 1 SAM GUI

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 45 46

Pas de commentaire

Hp LTO 4 SAS Manuel d'utilisateur Page 14