Hp PCI SCOPE PREPROCESSOR FSPCI64S Manuel d'utilisateur télécharger pdf (Page 11)

Analog Analysis

Since the PCI Scope Preprocessor interface contains only

passive matching terminators it introduces negligible skew to the

PCI Local Bus signals.

The following procedure describes the major steps required to

perform analog analysis measurements with the PCI Scope

Preprocessor module.

1. Install the PCI Scope Preprocessor module into a slot in

the target PCI Local bus.

2. Load the PCI MultiProbe configuration file

PCI_MUL.DUT from the MULTIPRB directory on the

hard disk. See page 9 for details on how to load this

file.

Once the file is loaded the POD that is connected to the PCI

Scope Preprocessor will be assigned the name PCI LogicScope

as shown below

Installation Quick

Reference

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Hp PCI SCOPE PREPROCESSOR FSPCI64S Manuel d'utilisateur Page 11