HP Mobile Accessory Kit Manuel d'utilisateur télécharger pdf (Page 9)

Installing the Wireless Mini Mouse

STEP 1 - Battery Installation:

1 - Locate the 2 AAA sized 1.5 Volt batteries that came in your HP Mobile

Accessory Kit package.

2 - Remove the battery compartment cover located on top of your mouse by sliding

the cover backwards.

3 - Install the two batteries into the compartment paying close attention to proper

polarities, and then close the battery compartment cover.

4 - Turn the mouse on by moving the switch on the bottom of the mouse to the ON position.

STEP 2 - Connecting the Receiver:

1 - Turn on your computer and wait for it to completely load.

2 - Locate the channel select switch on both the receiver and mouse. Switch both

the mouse and receiver to channel 1 or channel 2.

3 - Connect the receiver to any available USB port or hub connected to your

computer. Your mouse is now ready for use.

Note: To prolong battery life, make sure the mouse is turned off when not in use.

- 9 -

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

HP Mobile Accessory Kit Manuel d'utilisateur Page 9