HP 14-3100eb SPECTRE Informations techniques télécharger pdf (Page 71)

Reverse this procedure to install the processor heat sink.

Remove the post controller hub heat sink:

1. Loosen the captive Philllips screw (1) that secures the post controller hub heat sink to

the system board.

2. Remove the post controller hub heat sink (2).

NOTE: Due to the adhesive quality of the thermal material located between the post controller

hub heat sink and system board, it may be necessary to move the post controller hub heat sink

from side to side to detach it.

The thermal material must be thoroughly cleaned from the surfaces of the post controller hub heat sink

and the post controller hub each time the post controller hub heat sink is removed. Replacement thermal

material is included with the post controller hub heat sink and system board spare part kits.

Component replacement procedures

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 97 98

Pas de commentaire

HP 14-3100eb SPECTRE Informations techniques Page 71