
1. Turn on the computer.
2. Hold the disc by the edges to avoid touching the at surfaces and position the disc label-side up.
3. Gently slide the disc into the slot-load optical drive.
Removing an optical disc
Tray-load
There are 2 ways to remove a disc, depending on whether the disc tray opens normally or not.
When the disc tray opens normally
1. Press the release button (1) on the drive bezel to release the disc tray, and then gently pull out the tray
(2) until it stops.
2. Remove the disc (3) from the tray by gently pressing down on the spindle while lifting the outer edges of
the disc. Hold the disc by the edges and avoid touching the at surfaces.
NOTE: If the tray is not fully accessible, tilt the disc carefully as you remove it.
3. Close the disc tray and place the disc in a protective case.
When the disc tray fails to open normally
1. Insert the end of a paper clip (1) into the release access in the front bezel of the drive.
2. Press in gently on the paper clip until the tray is released, and then pull out the tray (2) until it stops.
40 Chapter 8 Drives
Commentaires sur ces manuels