HP Notebook Series Manuel d'utilisateur télécharger pdf (Page 62)

Add-On Devices

Reference Guide 5–13

To Replace the Hard Drive Holder

If you are installing a new hard drive that does not have a holder,

you can remove the holder parts from the hard drive you are

removing. You will need a small Phillips screwdriver for this

procedure.

1. Remove the 4 screws from the sides of the holder and drive

case, then slide the drive out of the holder.

2. Notice that the hard drive has a pin connector attachment at

one end. Carefully remove this connector from the end of the

drive. Work alternately at each end so that the connector

slides off evenly without bending the connector pins.

3. Carefully put the pin connector attachment back onto the pins

on the end of the new hard drive. Work alternately at each end

so that the connector slides on evenly without bending the

connector pins.

4. Insert the drive into the holder.

5. Reinstall the screws into the holder and drive case.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 101 102

Pas de commentaire

HP Notebook Series Manuel d'utilisateur Page 62