HP OmniBook 900 Manuel d'utilisateur télécharger pdf (Page 27)

HP OmniBook 900 Removal and Replacement 2-7

Removal Procedure

1. Unplug the ac adapter, if present, and remove the battery.

2. Turn the unit bottom side up and remove the hard drive screw from the bottom case.

3. Open the hard drive door, then pull out the hard drive by its plastic tab.

Figure 2-4. Removing the Hard Disk Drive

4. If you are installing a new hard drive that does not have a cover, you can remove the cover parts

from the old hard drive:

• Remove the two screws from the case, then lift the plastic tab and remove the plastic cover

and metal shield from the hard disk drive.

• Carefully pry the connector off the end of the hard disk drive. Work alternately at each end so

that the connector slides off evenly.

Figure 2-5. Installing a Hard Drive in the Cover

Screw, M2.5×5mm

Screw, M3×4mm

HDD cover kit

Hard disk drive

Small tabs on connector

face down in this view.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 97 98

Pas de commentaire

HP OmniBook 900 Manuel d'utilisateur Page 27