HP Omnibook XE3 Manuel d'utilisateur télécharger pdf (Page 34)

2-12 Removal and Replacement HP Omnibook XE3 (Technology Codes GE and GD)

Removing the Keyboard

(HP Authorized Service Providers Only)

Required Equipment

•

#0 Phillips screwdriver.

•

Small flat-head screwdriver.

Removal Procedure

Unplug the AC adapter, if present, and remove the battery.

Remove the keyboard cover (page 2-10).

Loosen the four retaining screws along the top of the keyboard (the keyboard retains the screws).

Figure 2-8. Loosening the Keyboard Retaining Screws

Raise the top of the keyboard, then lift the keyboard up and out of the notebook. Be careful not to

pull on the ribbon cable connecting the keyboard to the notebook.

Caution

Be careful not to touch the heatsink until it has cooled. It could be hot if the notebook was running

recently.

Lay the keyboard face down on the top case, forward of its normal position, and disconnect the

ribbon cable from the motherboard.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 115 116

Pas de commentaire

HP Omnibook XE3 Manuel d'utilisateur Page 34