HP Server tc2110 Guide d'installation télécharger pdf (Page 18)

Chapter 3 Installing Microsoft Windows NT 4.0 Server

PHASE 7 – Install HP Video Driver

The Microsoft Windows installation process has installed the standard VGA video

driver. If you would like to make use of the high-resolution video driver, follow

these steps:

1. Ensure Microsoft Windows NT Service Pack (version #6a or above) is

installed. This is a REQUIREMENT.

2. Logon as the Administrator on your HP server then insert HP Startup CD in

the CD-ROM drive. The Startup CD will automatically start and a menu will

display.

NOTE Your HP server should auto-detect the presence of the Startup

CD and start the Startup menu. If your HP server does not

auto-start the Startup menu, start it by opening Startup.htm

which can be found at the root level of the Startup CD.

3. Select ""the NT 4.0 video driver in the "Drivers summary table / accessing hp

drivers" page.

4. The HP video driver setup program will open. Click Next to start the

installation.

5. Select “NVIDIA Vanta”.

6. Click Finish when prompted to restart your system at the end of the

installation.

7. After your logon, you will be notified that default display resolutions are

being used. Click OK. You can now configure your settings and test them.

Section 4. Initialize Hard disk Drive

To manage your different drives and partitions:

1. Click Start | Programs | Administrative Tools | Disk Administrator.

2. Click OK to proceed when notified you have a new hard disk to configure.

3. Select available hard disk space on the graphic and use menus to create

additional partitions.

4. Exit the Disk Administrator.

5. To complete formatting of new partitions, open My Computer, right click on

a new partition(s) to be formatted and select format.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 64 65

Pas de commentaire

HP Server tc2110 Guide d'installation Page 18