HP LASERJET 5100LE Manuel d'utilisateur télécharger pdf (Page 32)

30 Printer description Q1860-90918

Envelopes that have double side seams

Double-side-seam construction has vertical seams at both ends of the envelope rather than

diagonal seams. This style can be more likely to wrinkle. Be sure that the seam extends all the

way to the corner of the envelope as illustrated below.

Figure 5. Envelopes with double side seams

Envelopes that have adhesive strips or flaps

Envelopes that have a peel-off adhesive strip or more than one flap that folds over to seal must

use adhesives that are compatible with the heat and pressure in the printer. The extra flaps and

strips might cause wrinkling, creasing, or jams.

Envelope margins

The following table shows typical address margins for a Commercial #10 or DL envelope.

Note For the best print quality, position margins no closer than 15 mm (0.6 inch) from the edges of the

envelope.

Envelope storage

Proper storage of envelopes helps contribute to good print quality. Envelopes should be stored

flat. If air is trapped in an envelope, creating an air bubble, the envelope might wrinkle during

printing.

Acceptable

Unacceptable

Table 11. Envelope margins

Type of address Top margin Left margin

Return address 15 mm (0.6 inch) 15 mm (0.6 inch)

Delivery address 51 mm (2 inches) 89 mm (3.5 inches)

www.GovTechMedia.com

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 313 314

Pas de commentaire

HP LASERJET 5100LE Manuel d'utilisateur Page 32