HP EPM-442A Manuel d'utilisateur télécharger pdf (Page 114)

HP4402.book : chapter3.fm 12 Wed Apr 23 15:29:05 1997

Menu Reference

Front Panel Menu Reference "Frequency/Cal Fac" Menu

3-12 HP EPM-442A User’s Guide

•

Press this softkey to enter the measurement calibration factor for

channel A in the range of 1% to 150%. The default value is 100%.

Use the , , and hardkeys to change the

calibration factor. To conﬁrm your choice press . Entering a

calibration factor using this softkey is only possible when you are

using an HP 8480 series power sensor.

•

Press this softkey to enter the frequency of the signal to be

measured on channel B, in the range of 0.1 MHz to 999.999 GHz.

The default value is 50 MHz. Use the , , and

hardkeys to change the frequency. To conﬁrm your choice press the

appropriate frequency unit. Entering a frequency using this

softkey is only possible when you have a sensor calibration table

selected or you are using an HP E-series power sensor.

•

Press this softkey to enter the measurement calibration factor for

channel B in the range of 1% to 150%. The default value is 100%.

Use the , , and hardkeys to change the

calibration factor. To conﬁrm your choice press . Entering a

calibration factor using this softkey is only possible when you are

using an HP 8480 series power sensor.

A Cal Fac

B Freq

B Cal Fac

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 163 164

Pas de commentaire

HP EPM-442A Manuel d'utilisateur Page 114