Hp LaserJet Pro MFP M227fdw Manuel d'utilisateur télécharger pdf (Page 52)

Additional statements for telecom (fax) products

EU Statement for Telecom Operation

This product is intended to be connected to the analog Public Switched Telecommunication Networks (PSTN) of

European Economic Area (EEA) countries/regions.

It meets requirements of EU R&TTE Directive 1999/5/EC (Annex II) and carries appropriate CE conformity

marking.

For more details see Declaration of Conformity issued by the manufacturer in another section of this manual.

However due to dierences between individual national PSTNs the product may not guarantee unconditional

assurance of successful operation on every PSTN termination point. Network compatibility depends on the

correct setting being selected by the customer in preparation of its connection to the PSTN. Please follow the

instructions provided in the user manual.

If you experience network compatibility issues, please contact your equipment supplier or HP help desk in the

country/region of operation.

Connecting to a PSTN termination point may be the subject of additional requirements set out by the local PSTN

operator.

New Zealand Telecom Statements

The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the

item complies with minimum conditions for connection to its network. It indicates no endorsement of the

product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item

will work correctly in all respects with another item of Telepermitted equipment of a dierent make or model,

nor does it imply that any product is compatible with all of Telecom’s network services.

This equipment may not provide for the eective hand-over of a call to another device connected to the same

line.

This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency Service.

This product has not been tested to ensure compatibility with the FaxAbility distinctive ring service for New

Zealand.

Additional FCC statement for telecom products (US)

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the back

of this equipment is a label that contains, among other information, a product identier in the format

US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.

The REN is used to determine the quantity of devices, which may be connected to the telephone line. Excessive

RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not

all, areas, the sum of the RENs should not exceed ve (5.0). To be certain of the number of devices that may be

connected to the line, as determined by the total RENs, contact the telephone company to determine the

maximum REN for the calling area.

This equipment uses the following USOC jacks: RJ11C.

An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed

to be connected to the telephone network or premises wiring using a compatible modular jack, which is Part 68

compliant. This equipment cannot be used on telephone company-provided coin service. Connection to Party

Line Service is subject to state taris.

44 Chapter 3 Regulatory information ENWW

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Pas de commentaire

Hp LaserJet Pro MFP M227fdw Manuel d'utilisateur Page 52