HP 1000s Manuel d'installation télécharger pdf (Page 22)

22 NAS 1000s Quick Start Guide

Setup and Configuration Overview

Setting up systems is a well-defined process. This section is

intended as an overview of the process, not a detailed list of

step-by-step instructions. Step-by-step procedures are

documented in the administration guide. Some of the steps are

driven by wizards within the WebUI. In either type of setup, it is

important to read all of the supplied documentation before

starting. Relevant documents include:

■ HP StorageWorks NAS 1000s Administration Guide

■ HP StorageWorks NAS 1000s Rack Installation Instructions

■ HP StorageWorks NAS 1000s Release Notes (if required, this

document will be available via

www.hp.com

)

Configuring the NAS 1000s

The following describes how to configure the NAS 1000s.

1. Configure the NAS device using Chapter 2 of this guide.

2. This is a recommended step. Place the NAS device into an

Active Directory or Windows NT 4.0 domain for ease of

manageability.

3. Configure the NAS 1000s device using Chapter 3 of this

guide.

4. Using Logical Disk Manager (LDM), assign drive letters or

mount points, and format the data drives. See the LDM online

help for full details on this procedure.

5. This is an optional step. Enable protocols such as NFS

sharing, NCP, and/or AppleTalk. See the administration guide

for this procedure in detail.

6. This is an optional step. Create shares corresponding to the

protocols mentioned in the previous steps. Grant access rights

to the shares.

7. Read the remaining sections of the administration guide.

chap1.fm Page 22 Thursday, May 15, 2003 4:33 PM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Pas de commentaire

HP 1000s Manuel d'installation Page 22