HP ProCurve Series Manuel d'utilisateur télécharger pdf (Page 56)

3-2

Getting Started With Switch Configuration

Using the Console Setup Screen

Getting Started With Switch

Configuration

Note By default, the switch is configured to acquire an IP address configuration

from a DHCP or Bootp server. To use DHCP/Bootp instead of the manual

method described in this chapter, see “DHCP/Bootp Operation” in the

Management and Configuration Guide, which is on the ProCurve Web site,

www.procurve.com. (See page 5-1 for details.)

Using the Console Setup Screen

The quickest and easiest way to minimally configure the switch for manage-

ment and password protection in your network is to use a direct console

connection to the switch, start a console session, and access the Switch Setup

screen.

1. Using the method described in the preceding section, connect a terminal

device to the switch and display the switch console command (CLI)

prompt (the default display).

The CLI prompt appears displaying the switch model number:

ProCurve Switch 3500yl-48G#

2. At the prompt, enter the setup command to display the Switch Setup

screen. The following illustration shows the Setup screen with the default

settings.

Figure 3-1. CLI switch setup screen.

3. Use the

[Tab] key to select the Manager Password field and enter a manager

password of up to 16 characters.

3500yl-48G

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 109 110

Pas de commentaire

HP ProCurve Series Manuel d'utilisateur Page 56