HP 3C509B-TP Manuel d'utilisateur télécharger pdf (Page 15)

3 Connecting to a Windows NT Server 3.51

Windows for Workgroups Ver. 3.11

3 Connecting to a Windows NT Server 3.51

Windows for

Workgroups Ver. 3.11

Requirements

• HP Vectra with DOS and MS-Windows for Workgroups 3.11 installed.

• 3COM Etherlink 3C509-B ethernet card and drivers disk ver. 5.0.

D r i v e r N a m e : E l n k 3 . S Y S S i z e : 2 7 K B D a t e : 7 / 1 8 / 9 6

• Microsoft Windows NT Server 3.51 machine that supports Net BEUI,

NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

• I/O Base Address 300h

• Interrupt Request Level 10

• Boot PROM Disabled

• Transceiver Type Auto Select

• Network Driver Optimization Windows or OS/2 Client

• Maximum Modem Speed 9600 Bps

• Plug and Play Compatibility Disabled

• Full Duplex Disabled

Procedure

1 With the HP Vectra turned off, install the 3COM Etherlink III 3C509-B

adapter card into an ISA slot.

2 Connect network Cable Media to the 3COM 3C509B card.

3 After booting to DOS, insert the 3COM’s drivers disk “Etherlink 3C509-B

Ethernet ver. 5.0.”, and execute “A:\3C5X9CFG.EXE.”

4 Select “CONFIGURE NIC,” and verify the resource settings listed above

under the heading “Device Configuration.”

5 If changes are required, save those changes and exit.

6 Remove the 3COM Drivers diskette and reboot the machine.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Pas de commentaire

HP 3C509B-TP Manuel d'utilisateur Page 15