HP J3188A Manuel d'utilisateur télécharger pdf (Page 12)

1-2

Installing the Hub

Installing and Configuring Your Hub

Installing the Hub

Installing and Configuring Your Hub

To install and configure your hub, you must complete five basic tasks. They

are:

■ locating and verifying the necessary parts

■ connecting an external transceiver (if necessary)

■ connecting the hub to a power source

■ mounting the hub

■ connecting the hub to your network

1. Verify included parts

Each Hub-16M has the following components shipped with it:

■ HP 10Base-T Hub-16M (J3188A) Installation and Reference Guide—

this manual (J3188-90001)

■ A U.S./Canada/Mexico (8120-1378) power cord.

■ Accessory kit (5064-2053):

• bumper feet (4)

• hub-to-rack screws 10-32 (4)

• bracket-to-hub screws 10-32 (4)

• nylon finishing washer (4)

• bracket-to-hub screws (2)

• AUI retainer assembly

2. Connect the external transceiver

Because of the way the external transceiver protrudes out from hub once it is

connected, you may want to install the external transceiver before installing

the hub. Inspect your installation site and identify whether enough room will

be available for the external transceiver to be connected. Then see your

external transceiver guide for installation instructions.

3. Verify the hub operates correctly

Before mounting the hub, connect it to a power source and verify the hub will

operate correctly.

MUCHO.BK : ch1.fm5 Page 2 Thursday, June 26, 1997 11:37 AM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 99 100

Pas de commentaire

HP J3188A Manuel d'utilisateur Page 12