HP EliteOne 800 Guide de l'utilisateur télécharger pdf (Page 43)

7. Pull the latch next to the lower side of the 2.5-inch hard disc drive cage away from the cage to

release it, then slide the cage toward the edge of the chassis and lift it out.

Figure 2-35 Removing the 2.5-inch hard disc drive cage

8. If there is a second disc drive in the 2.5-inch cage, disconnect both cables from it.

9. Remove the four mounting screws from each 2.5-inch hard disc drive to be removed. Be sure to

keep the screws together with the blue rubber grommets to use to install a replacement drive.

NOTE: The primary drive is the lower position in the drive cage. If only one drive is to be

installed, it must occupy this position.

Figure 2-36 Removing the mounting screws

10. Remove the 2.5-inch hard disc drive(s) from the cage.

For instructions on installing a hard disc drive, see

Installing a 2.5-inch hard disc drive on page 38.

Replacing drives 37

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 53 54

Pas de commentaire

HP EliteOne 800 Guide de l'utilisateur Page 43