HP J Class 3 - For Visualization Center Guide de l'utilisateur télécharger pdf (Page 86)

ﬁle conﬁguration

Chapter 386

process, all of the following ﬁles are automatically conﬁgured. Use these

instructions to verify that all ﬁles are customized appropriately for any

hardware changes, hostnames or IP addresses that were made.

• /.rhosts - Editing this ﬁle allows root access to other systems.

Root permissions are required to edit many of the conﬁguration ﬁles

described in this section. It is very handy to allow root access to all

systems so it’s easy to use remsh to access each of them. A copy of

this ﬁle is on each system.

Optionally, you may choose to remove this ﬁle from each system to

disallow root access from other systems.

svm root

sv1 root

sv2 root

sv3 root

sv4 root

sv5 root

sv6 root

sv7 root

sv8 root

• /etc/X11/X0screens - Edit the X0screens ﬁle on the MASTER

ONLY!

— There is a sample X0screens ﬁle template for each supported

hardware conﬁguration. Use these templates to create the

/etc/X11/X0screens ﬁle to be used to conﬁgure the X server.

For example, if you had an 8-pipe, two channel system (18

workstations displaying to two monitors):

To replace the existing X0screens ﬁle on the master system:

cd /usr/lib/X11/xserver/misc/slsd/templates

cp X0screens.p8c2 /etc/X11/X0screens

— Edit the ﬁle to change hostname and IP addresses. Add or

remove comment delimiters (#) to enable the desired screen

options or environment variables.

— See /usr/lib/X11/Xserver/info/screens/hp for general

X0screens syntax that is not hp visualization center sv6-speciﬁc.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 119 120

Pas de commentaire

HP J Class 3 - For Visualization Center Guide de l'utilisateur Page 86