HP LC2000r - NetServer - 128 MB RAM Guide d'installation Page 19
- Page / 194
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Chapter 2 Controls, Ports and Indicators
11
Front Panel LED Indicators
Table 2-2. Component Indicators
LED ICON Description
Disk LED
This Disk LED has two distinctive states:
off for inactive operation
blinking Green for SCSI drive activity.
Temperature
LED
This Temperature LED has three distinctive colors:
steady Green for normal operation
blinking Red at 1 Hz blink rate for an
overheated condition inside the HP NetServer
blinking Amber at 0.5 Hz blink rate for a
warning condition.
Fan LED
This Fan LED has three distinctive colors:
steady Green for normal operation
blinking Red at 1 Hz blink rate for a non-
operational fan condition inside the NetServer
blinking Amber at 0.5 Hz blink rate for a
warning condition indicating one of the fans
may be turning too slowly.
RPS LED
This RPS (Redundant Power Supply) LED has three
distinctive colors:
steady Green for normal operation
blinking Red at 1 Hz blink rate for a bad power
supply
blinking Amber at 0.5 Hz blink rate for a
warning condition indicating a power supply
may not be working correctly.
Reserved
This LED is reserved and not used in this release.
- HP NetServer LC 2000/2000r 1
- Installation Guide 1
- Contents 3
- 1 Setting Up the HP NetServer 9
- Pedestal Installation 10
- Rack Mount Installation 13
- Front of HP NetServer 17
- Front Panel LED Indicators 19
- Power Supply Module Indicator 23
- Keyboard Mouse 24
- Video NIC 24
- (Embedded) 24
- Management 24
- NIC Indicators 25
- Link/Activity 25
- Transfer Rate 25
- Powering Up the HP NetServer 26
- Sleep States (ACPI) 27
- 3 Opening and Closing the HP 29
- NetServer 29
- Foot (4) 31
- Anti-Tip 31
- Foot Extended 31
- Slide Securing Screws (2) 33
- Hinge Pins(3) Handles(2) 33
- Top Cover 35
- Bottom Cover 35
- Cover Pull 35
- Right Cover 38
- Thumbscrews (2) 38
- Removing the Pedestal 40
- Hardware Mirroring 43
- Mass Storage Guidelines 44
- • General Guidelines 44
- • SCSI Device Selection 44
- • SCSI Drive Addressing 45
- • Filler Panels and Spacers 46
- Filler Panels 47
- Pedestal Configurations for 48
- Note: Con = Connector 49
- Connectors A and B 50
- Con = Connector 50
- Cabling Configurations 51
- Drive Spacer 55
- Locking Latch 56
- Removing Hot Swap Hard Drives 58
- Non-Hot Swap 59
- (Optional) 59
- DIMM Installation 64
- DIMM Removal 67
- Boot Priority 70
- IRQ Settings 71
- System Board PCI Slots 71
- Installing Accessory Boards 73
- 1. Open Tab 75
- 2. Lift Latch 75
- 3. Remove Slot Cover 75
- 1. Insert Board 77
- 2. Close Latch 77
- 3. Turn Tab 77
- Figure 7-1. System Board 80
- Installing the Processor 81
- Processor Cage 83
- Terminator 84
- Figure 7-6. Installing VRM 86
- Channel(2) 97
- Rear of HP NetServer 101
- Left Rear 101
- Rack Column 101
- Cable Management Arm 101
- Attaching the Front Bezel 102
- Mouse, and UPS 105
- Introduction 107
- HP NetServer Navigator CD-ROM 107
- Internet FTP 109
- Assistant 111
- • Show System Information: 113
- • Configure Disk Array: 113
- • Install Utility Partition: 113
- • Execute Card Utilities: 113
- NOS Installation 115
- HP Management Solutions 116
- Setup Utility 120
- Using the Setup Screens 121
- • Small arrow points ( 122
- ➢Hardware Security 123
- Floppy check: [Disabled] 126
- Summary screen: [Enabled] 126
- Quick Boot mode: [Enabled] 126
- ➢Boot Device Priority 126
- ➢Hard Drive Priority 126
- Clearing CMOS 128
- SCSI Configuration Utility 129
- 11 Information Assistant 135
- Installing from the CD-ROM 137
- :\infoasst\setup 137
- 12 Troubleshooting 139
- Common Installation Problems 140
- Chapter 12 Troubleshooting 141
- Error Message Is Displayed 142
- No Error Messages Displayed 143
- Open = Off 145
- Closed = On 145
- Hardware Problems 147
- Keyboard or Mouse Do Not Work 148
- CD-ROM Drive Does Not Work 148
- Password Problems 149
- Battery Problems 150
- 13 Alternative Rack Mounting 153
- Tools Required 154
- • Nut driver or wrench 154
- • T-15 and T-25 Torx Drivers 154
- • Marking pen 154
- Preparing the Rack 156
- Slide Members 161
- Screws (4) 161
- Mounting 162
- Channels(2) 162
- A Specifications 169
- Appendix A Specifications 170
- Environmental Requirements 171
- Physical Requirements 172
- Video Support 173
- B Regulatory Information 175
- Notice for Japan 177
- Notice for Korea 178
- Notice for Taiwan 179
- Notice for European Union 179
- Battery Statements 183
- C Service and Support 185
- Warranty 187
Produits connexes et manuels pour PC/postes de travail HP LC2000r - NetServer - 128 MB RAM
(138 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.134 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels