HP Notebook Series Guide de l'utilisateur télécharger pdf (Page 72)

Add-On Devices

Replacing the Hard Drive

Reference Guide 63

To replace the hard drive holder

If you are installing a new hard drive that does not have a holder, you can remove the

holder parts from the old hard drive. You will need a small Phillips screwdriver for

this procedure.

1. Remove the four screws from the sides of the holder and drive case, then slide

the drive out of the holder.

2. Notice that the hard drive has a pin connector attachment at one end. Carefully

remove this connector from the end of the drive. Work alternately at each end so

that the connector slides off evenly without bending the connector pins.

3. Carefully put the pin connector attachment back onto the pins on the end of the

new hard drive. Work alternately at each end so that the connector slides on

evenly without bending the connector pins.

4. Insert the drive into the holder.

5. Reinstall the screws into the holder and drive case.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 120 121

Pas de commentaire

HP Notebook Series Guide de l'utilisateur Page 72