HP TouchSmart 9300 Elite Guide de l'utilisateur télécharger pdf (Page 18)

Installing the Rear Port Security Cover

1. Ensure that all cables are connected and the rear port access door is closed.

2. Tilt the display head to its most forward position and slide it down to its lowest position so that

the stand does not cover any of the center cavity.

3. Place the port security cover into the cavity ensuring that the cables are fitted into the slots on

the security cover (1) and tighten the captive screw (2).

Figure 2-5 Installing the Rear Port Security Cover

NOTE: You can further secure the rear ports by installing a security lock into the slot just above the

captive screw on the rear port security cover. Refer to

Installing a Security Lock on page 28.

Removing the Rear Port Security Cover

1. Tilt the display head to its most forward position and slide it down to its lowest position so that

the stand does not interfere with removing the port security cover.

2. If a security lock is installed on the rear of the unit, remove the lock.

12 Chapter 2 Hardware Upgrades ENWW

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 44 45

Pas de commentaire

HP TouchSmart 9300 Elite Guide de l'utilisateur Page 18